Voyagers of Nera

Change the autosave interval on a Voyagers of Nera server

Autosave Timer is measured in seconds. The installed server configuration accepts values from 10 to 900 and writes the result into CustomHostServerUserSettings.ini.

Make the change

  1. Stop the server normally and back up the current BoatGame/Saved data.
  2. Open Startup and record the current Autosave Timer.
  3. Choose an interval in seconds, such as 300 for five minutes, and save it.
  4. Start and play long enough for an autosave to occur.
  5. Stop normally, start again and check that a recent change to the world persists.
Startup variables for Voyagers of Nera. Use the field labels in the steps; keep private credentials hidden when sharing screenshots.
Controls used in this task
Panel fieldWhat to keep in mind
Autosave TimerTime between autosaves, in seconds. 300 means five minutes; the server configuration accepts 10 through 900. Allowed range: 10–900.

Check the result

Shorter intervals increase save frequency, but an autosave is not a separate panel backup. Keep independent backups before major changes so a damaged or unwanted save does not replace your only recovery copy.

Related guides

Voyagers of Nera server not showing up or unable to connect · Voyagers of Nera server settings: Startup and configuration

Documentation

Server configuration reference

Voyagers of NeraGame managementGame panel
Was this article helpful?

Your feedback helps us improve our guides.

Written by Konnect HostingUpdated 1 min read
Accepted payment methods

© 2026 Konnect Hosting. All rights reserved.