Left 4 Dead

Choose the first campaign map on a Left 4 Dead server

Default Map should be a valid opening map for the campaign you want to host. Starting in the middle of a custom campaign can make troubleshooting transitions harder.

Make the change

  1. Check the campaign’s internal map names and install its complete required content.
  2. Record the current Default Map and back up left4dead configuration and custom files.
  3. Stop the server and set Default Map to the intended opening map without .bsp.
  4. Start, join a fresh session and verify the campaign loads.
  5. Test at least one chapter transition before treating a custom campaign as ready for players.
Controls used in this task
Panel fieldWhat to keep in mind
Default MapSelects the map loaded by this server. Use an exact installed map identifier supported by the game, including any required path. Up to 40 characters.

Check the result

If the first map works but a later chapter fails, inspect that chapter’s map name and missing files. Avoid replacing a working connection configuration to repair an incomplete campaign package.

Related guides

Left 4 Dead server not showing up or unable to connect

Documentation

Server configuration reference · Project documentation 2

Left 4 DeadGame managementGame panel
Was this article helpful?

Your feedback helps us improve our guides.

Written by Konnect HostingUpdated 1 min read
Accepted payment methods

© 2026 Konnect Hosting. All rights reserved.